Fitting the Xtreme Landing Skid and Battery holder set.

The first thing to do is to remove the skids from the helicopter. If you have the antenna around the skids you will need to unravel it and roll it up so it doesn't get in the way. Un-clip the battery holder and remove the 4 screws holding the skids to the main body (Illustration 1) once the skids are free of the body, carefully un-stick the 4-in1 from it's tray.

Illustration 1.	Illustration 2.

Now we can prepare the Extreme skids. first get the battery holder and the 4-in-1 tray and using the long screws provided screw the tray to the holder but do not screw all the way (Illustration 3) just enough to put the screw through the hole in the skids.

Illustration 3.

Now but the left skid arm on the assembly above and screw it to the body. Do the same on the right side arm. You will now have the hole assembly connected to the main body by the front two screws.(Illustration 4) If you are not fitting the Xtreme Graphite Tail boom full set then secure the back of the assembly by inserting two screw at the back

Illustration 4.

All that needs to be done now is connect the support arm and the skids as in the picture below.

Click the picture to enlarge the diagram in a new window.